LABELLING TAPE - INSULATION TAPE PVC
Made in EU
With PVC labeling tape, easily mark and inscribe and insulate everything at events or make floor markings to position stage sets or decorative pieces.
PVC labeling tape is made of a surface-friendly adhesive on a soft PVC carrier.
Due to the breakdown voltage of 6 (KV), PVC labeling tape can also be used as insulating tape.
Carrier: Soft PVC foil
Total thickness: 0.12 mm
Adhesive base: Synthetic rubber
Adhesive force: >= 1.6 N/cm I > = 4.0 N/25mm
Tensile strength: >= 20 N/cm I > = 50 NN/25mm
Elongation at break: >100%
Temperature resistance: -10 °C to 105 °C
UV resistance: limited
Breakdown voltage: 6 (KV)
Weather resistance: good
Processing temperature: recommended >= 5 °C
Core diameter: 38 mm
Shelf life: 6 months at 18 °C
Storage conditions: 5 °C to 25 °C, dry, UV protected
Jetzt anmelden/registrieren und Downloads freischalten
No downloads are available for this sales item.
Technische Details:
- width 19mm
- appr. 33lm rolls
Warning & Application Instructions for ADHESIVE TAPES
Valid from January 1, 2014
1. Adhesive tape ratings
Please note that the ratings are based on comparisons within our product range.
2. Adhesive residues
Please note that all adhesive tapes, even with the best rating, can leave adhesive residues depending on the surface, pressure, mechanical stress, and application duration.
3. Aging of adhesive tapes
Please note that adhesive tapes may age during storage (more than 1-2 years), depending on the temperature, which alters their properties, particularly adhesion and residue behavior.
4. Caution with stone floors and porous surfaces
Be especially cautious with stone floors and other porous surfaces such as terracotta or clinker, as these often absorb chemical components of adhesives, which can lead to dark streaks on the stone that fade only slowly or not at all.
5. Proper tape removal technique
Always remove adhesive tapes evenly. Jerky removal increases the likelihood of leaving adhesive residues and can damage the substrate due to material peeling. Pay particular attention to this on wooden floors, lacquered and coated surfaces, and other sensitive surfaces.
6. Testing before use
Always test before use:
6.1. on the respective surfaces,
6.2. according to the planned duration of adhesion,
6.3. under the planned mechanical stress,
6.4. under the planned mechanical pressure.
7. Complaints and disclaimer of liability
If adhesive residues and other results are due to the typical properties of an adhesive tape, complaints are excluded. Claims for damages are in any case excluded.
